Glowshift Air / Fuel Ratio Gauge User Manual download pdf

Tinted Series Narrowband Air/Fuel Ratio Gauge

For Product Numbers: GS-T02

Wire Harness Color Code

Red:

12v Ignition Source (+) (

switched

)

Orange:

12v Switched Headlamp Source (+) (

optional

)

Black:

Vehicle Ground ( - )

Green:

Connects to Vehicle 0v-1v Narrowband O2 Sensor Signal Wire

1. Disconnect the vehicle's negative battery cable.

Gauge Installation

2. Air / Fuel Ratio: Connect the green wire to the vehicle

oxygen sensor signal wire, before the catalytic convertor.

You may connect this wire directly to the ECU harness or

splice into the signal wire leaving the sensor. This wire color

can vary, be sure to consult your vehicle’s owner’s manual.

(0v ~ 1v Output - NARROW BAND ONLY)

Note: If your vehicle does not have a narrowband o2 sensor,

you will have to purchase a single wire or 4 wire narrowband

o2 sensor to complete this installation.

Connecting the Power Wire Harness

3. To make the wiring of your gauges easier you can

purchase an expandable circuit. This component easily fits

into your fuse panel and provides an additional fused power

wire for accessories such as gauges. The expandable circuit is

available for purchase at www.GlowShift.com.

4. Using automotive grade wiring (18 gauge); connect the

red wire to a positive 12 volt ignition (switched) source. It

may be connected to the fuse panel, an accessory wire, or any

positive 12 volt source that turns on and off with the ignition.

5. Using automotive grade wiring (18 gauge); connect the

black wire to any good (unpainted) ground connection. You

may also route a wire directly to the negative side of the

vehicle’s battery.

6. The Night Time Dimming feature decreases the brightness

of the gauge face by 30%. Connect the orange wire to the 12

volt positive headlamp source. This allows the mode to be

activated when the headlights come on. This step is optional

and will not affect operation of the gauge if it is omitted.

 Note: Do not connect the orange wire to a dimmer

wheel. This will cause the gauge lighting to flicker.

7. Reconnect the vehicle's negative battery cable.

 Power on the vehicle to ensure the gauge is

functioning properly.

1 2

Summary of Contents

Page 1

Tinted Series Narrowband Air/Fuel Ratio Gauge For Product Numbers: GS-T02 Wire Harness Color Code Red: 12v Ignition Source (+) (switched) Orange: 1

Page 2

Additional Installation Information & Material Requirements  GlowShift Gauges Approved Conductor Wires: Successfully installing GlowShift Gauge

Glowshift Air / Fuel Ratio Gauge User Manual

Browse online or download User Manual for Accessories for water Glowshift Air / Fuel Ratio Gauge. GlowShift Air / Fuel Ratio Gauge User Manual

Summary of Contents

More documents for Accessories for water Glowshift Air / Fuel Ratio Gauge

Comments to this Manuals

Glowshift Air / Fuel Ratio Gauge User Manual

Browse online or download User Manual for Accessories for water Glowshift Air / Fuel Ratio Gauge. GlowShift Air / Fuel Ratio Gauge User Manual

Summary of Contents

More documents for Accessories for water Glowshift Air / Fuel Ratio Gauge

Comments to this Manuals

Related products and manuals for Accessories for water Glowshift Air / Fuel Ratio Gauge