Glowshift Vacuum Pressure Gauge User Manual download pdf

Tinted Series Vacuum Gauge

For Product Numbers: GS-T03

Wire Harness Color Code

Red:

12v Ignition Source (+) (switched)

Orange:

12v Switched Headlamp Source (+) (optional)

Black:

Vehicle Ground ( - )

1. Disconnect the vehicle's negative battery cable.

Gauge Installation

2. Run the vacuum line from the gauge through the firewall.

 Note: Make sure the vacuum line is not pinched; the

use of a rubber grommet through the firewall is

required.

3. Cut any vacuum line and insert the included T-fitting

between the two cut pieces of vacuum line. Insert

accordingly so that the intersecting cross piece of the fitting

with the brass pressure restrictor is left to be connected to the

vacuum gauge line.

 Note: If a vacuum line is not available to cut, you

may need to purchase a brass barbed fitting (with

restrictor) to install into the intake manifold to obtain

a vacuum pressure reading. This fitting can be

purchased at www.GlowShift.com.

Connecting the Power Wire Harness

4. To make the wiring of your gauges easier you can

purchase an expandable circuit. This component easily fits

into your fuse panel and provides an additional fused power

wire for accessories such as gauges. The expandable circuit

is available for purchase at www.GlowShift.com.

5. Using automotive grade wiring (18 gauge); connect the red

wire to a positive 12 volt ignition (switched) source. It may be

connected to the fuse panel, an accessory wire, or any positive

12 volt source that turns on and off with the ignition.

6. Using automotive grade wiring (18 gauge); connect the

black wire to any good (unpainted) ground connection. You

may also route a wire directly to the negative side of the

vehicle’s battery.

7. The Night Time Dimming feature decreases the brightness

of the gauge face by 30%. Connect the orange wire to the 12

volt positive headlamp source. This allows the mode to be

activated when the headlights come on. This step is optional

and will not affect operation of the gauge if it is omitted.

 Note: Do not connect the orange wire to a dimmer

wheel. This will cause the gauge lighting to flicker.

8. Reconnect the vehicle's negative battery cable.

 Power on the vehicle to ensure the gauge is

functioning properly.

1 2

Tinted Series Vacuum Gauge 1

Summary of Contents

Page 1 - Tinted Series Vacuum Gauge

Tinted Series Vacuum Gauge For Product Numbers: GS-T03 Wire Harness Color Code Red: 12v Ignition Source (+) (switched) Orange: 12v Switched Headla

Page 2

Additional Installation Information & Material Requirements  GlowShift Gauges Approved Conductor Wires: Successfully installing GlowShift Gaug

Comments to this Manuals

No comments

Glowshift Vacuum Pressure Gauge User Manual

Browse online or download User Manual for Accessories for water Glowshift Vacuum Pressure Gauge. GlowShift Vacuum Pressure Gauge User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories for water Glowshift Vacuum Pressure Gauge